Reference Guide

mep cross-check enable
Enable cross-checking.
S4820T
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port Down service with no VLAN association.
vlan-id Enter the VLAN to apply the cross-check.
Defaults none
Command Modes ECFM DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check operation is
started.
S4820T
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Enter a start-delay in seconds. The range is from 3 to 100 seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
147