Reference Guide

show config
Display the current ACL configuration.
S4820T
Syntax
show config
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(config-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(config-ext-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-
specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an
implicit permit.
The S4820T supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
177