Reference Guide

To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no permit udp {source mask | any | host ip-address}
{
destination mask | any | host ip-address command.
Parameters
source Enter the IP address of the network or host from which the packets
were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-
contiguous.
any Enter the keyword any to specify that all routes are subject to the
filter.
host ip-address Enter the keyword host and then enter the IP address to specify a
host IP address.
dscp Enter the keyword dscp to deny a packet based on the DSCP value.
The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports
for the
port parameter)
port port Enter the application layer port number. Enter two port numbers if you
are using the range logical operand. The range is 0 to 65535.
destination Enter the IP address of the network or host to which the packets are
sent.
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is from 0 to 254 (where 0 is the highest
priority and 254 is the lowest; lower-order numbers have a higher
priority). If you do not use the keyword order, the ACLs have the
lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
207