Reference Guide

Parameters
any Enter the keyword any to forward all packets.
host Enter the keyword host then a MAC address to forward packets
with that host address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
mac-destination-
address
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn
format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of the
following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword count to count packets the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the FTOS Configuration
Guide .
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
227