Reference Guide

match community
To match routes that have a certain COMMUNITY attribute in their BGP path, configure a filter.
S4820T
Syntax
match community community-list-name [exact]
To delete a community match filter, use the no match community command.
Parameters
community-list-
name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes
with this community list name.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
ip community-list — configures an Community Access list.
set community — specifies a COMMUNITY attribute.
neighbor send-community — sends COMMUNITY attribute to peer or peer group.
match interface
To match routes whose next hop is on the interface specified, configure a filter.
S4820T
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
240