Reference Guide

Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The community list used in the set comm-list delete command must be configured so
that each filter contains only one community. For example, the filter
deny 100:12 is
acceptable, but the filter deny 120:13 140:33 results in an error.
If the set comm-list delete command and the set community command are
configured in the same route map sequence, the deletion command (
set comm-list
delete) is processed before the insertion command (set community).
Related
Commands
ip community-list — configures community access list.
match community — redistributes routes that match the COMMUNITY attribute.
set community — specifies a COMMUNITY attribute.
set community
Allows you to assign a BGP COMMUNITY attribute.
S4820T
Syntax
set community {community-number | local-as | no-advertise | no-
export | none} [additive]
To delete a BGP COMMUNITY attribute assignment, use the no set community
{community-number | local-as | no-advertise | no-export | none}
command.
Parameters
community-
number
Enter the community number in AA:NN format where AA is the AS
number (2 bytes) and NN is a value specific to that autonomous
system.
local-AS Enter the keywords local-AS to drop all routes with the
COMMUNITY attribute of NO_EXPORT_SUBCONFED.
251