Reference Guide

Parameters
weight Enter a number as the weight used by the route meeting the route
map specification. The range is from 0 to 65535. The default is router-
originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the routes
with a higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you do not use the set weight command, router-originated paths have a weight attribute
of 32768 and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
S4820T
Syntax
show config
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
259