Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you enter the clear ip bgp flap-statistics command without any parameters,
all statistics are cleared.
Related
Commands
show debugging — views the enabled debugging operations.
show ip bgp flap-statistics — views the BGP flap statistics.
undebug all — disables all debugging operations.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
S4820T
Syntax
clear ip bgp peer-group peer-group-name
Parameters
peer-group-name Enter the peer group name to reset the BGP sessions within that peer
group.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
S4820T
Syntax
debug ip bgp [ip-address | peer-group peer-group-name] [in |
out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
303