Reference Guide

debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
S4820T
Syntax
debug ip bgp {ip-address | peer-group-name} soft-
reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name}
soft-reconfiguration command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is
specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
S4820T
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
308