Reference Guide

Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor advertisement-start
To send BGP routing updates, set the minimum interval before starting.
S4820T
Syntax
neighbor {ip-address} advertisement-start seconds
To return to the default value, use the no neighbor {ip-address}
advertisement-start command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
seconds Enter a number as the time interval, in seconds, before BGP route
updates are sent. The range is from 0 to 3600 seconds.
Defaults none
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
S4820T
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-group-
name} allowas-in command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
314