Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

311

312

313

314

315

316

317

318

319

320

Defaults Disabled.

Command Modes ROUTER BGP

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.8.1.0 Introduced on the S-Series.

Version 7.7.1.0 Introduced on the C-Series.

Usage

Information

To prevent loops, the neighbor ebgp-multihop command does not install the default

routes of the multihop peer. Networks not directly connected are not considered valid for best-

path selection.

neighbor fall-over

Enable or disable fast fall-over for BGP neighbors.

S4820T

Syntax

neighbor {ipv4-address | peer-group-name} fall-over

To disable, use the no neighbor {ipv4-address | peer-group-name} fall-

over command.

Parameters

ipv4-address

Enter the IP address of the neighbor in dotted decimal format.

peer-group-name

Enter the name of the peer group.