Reference Guide

Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
With FTOS version 8.3.1.0 and later, you can use the redistribute command to advertise
the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type
internal and applied outbound to an EBGP peer/peer-group, the advertised routes
corresponding to those peer/peer-groups have the IGP cost set as
MED.
If you do not configure the default-metric command, in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static and
connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the neighbor default-
originate command.
Related
Commands
neighbor default-originate — injects the default route.
redistribute ospf
Redistribute OSPF routes into BGP.
S4820T
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id Enter the number of the OSPF process. The range is from 1 to 65535.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify
1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPF internal routes only.
336