Reference Guide

route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a
configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
With FTOS version 8.3.1.0 and later, you can use the redistribute command to advertise
the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type
internal and apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other
parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external
type 2 routes. RFC does not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
S4820T
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to
4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
337