Reference Guide

Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp damp command shown in the following
example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened
route.
Reuse Displays the hour:minutes:seconds until the dampened route is
available.
Path Lists all the ASs the dampened route passed through to reach the
destination network.
Example
FTOS>show ip bgp dampened-paths
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
FTOS>
show ip bgp detail
Display BGP internal information for the IPv4 Unicast address family.
S4820T
Syntax
show ip bgp [ipv4 unicast] detail
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
347