Reference Guide

Defaults
• external-distance = 20
• internal-distance = 200
• local-distance = 200
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
CAUTION: Dell Networking recommends not changing the administrative distance of
internal routes. Changing the administrative distances may cause routing table
inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that
route is low. Routes assigned an administrative distance of 255 are not installed in the routing
table. Routes from confederations are treated as internal BGP routes.
Related
Commands
router bgp — enters ROUTER mode on the switch.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S4820T
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
373