Reference Guide

Version 7.2.1.0 Introduced on the E-Series TeraScale.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If
no neighbor is specified, debug is turned on for all neighbors.
Related
Commands
show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
ipv6 prefix-list
Configure an IPv6 prefix list.
S4820T
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
Related
Commands
show ipv6 prefix-list — View the selected IPv6 prefix-list.
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
S4820T
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to start
storing inbound routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing
inbound routing updates.
382