Reference Guide

Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
Version 8.3.19.0 Introduced on the S4820T.
Version 7.8.1.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced
Usage
Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP stores all
updates for inbound IPv6 unicast routes the neighbor receives but does not reset the peer-
session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP
update database from the neighbor is stored in memory regardless of the inbound policy
results applied on the neighbor.
Related
Commands
show ip bgp ipv6 unicast neighbors — displays IPv6 routing information BGP neighbors
exchange.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the internet and
connecting multicast topologies between BGP and autonomous systems (AS). FTOS MBGP is implemented as per IETF
RFC 1858.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
S4820T
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the
prefix length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
summary Display a summary of RPF routes.
383