Reference Guide

cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2
and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet
Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
S4820T
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number ecfmacl
number [vman-qos | vman-dual-qos number] ipv4pbr
number}openflow {4|8} | fcoe number}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number l2pt
number ipmacacl
number ecfmacl
number [vman-
qos | vman-dual-
qos number ]
ipv4pbr
number openflow
{4|8} | fcoe
number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be
allotted. The total space allocated must equal 13. The range for
ipv4acl is from 1 to 4. The ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256
total entries minus the 14 entries reserved for internal
functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512
total entries minus the 14 entries reserved for internal
functionality)
The fcoe range is 0–6 groups. Each group has 128 entries; the value
given must be an even number. This information is stored in the
NVRAM and is effective after rebooting the switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Added support for fcoe.
Version 9.1.(0.0) Added support for OpenFlow.
Version 8.3.19.0 Introduced on the S4820T.
386