Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.10.2 Clarified block information for the S4810.
Version 8.3.10.0 Introduced on the S4810.
Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these
blocks cannot be reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
There can be only one odd number of Blocks in the CLI configuration; the other Blocks must be
in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a
configuration of 6+4+2+1 Blocks is supported.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0
to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP 3.0, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload conditional
nvram-cfg-change
.
cam-acl-egress
Allocate CAM for egress ACLs.
S4820T
Syntax
cam-acl-egress default | l2acl
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space for Layer 2 egress ACL. The range is from 1 to 4 FP
blocks.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
387