Reference Guide

L2Acl : 5
Ipv4Acl : 5
Ipv6Acl : 1
Ipv4Qos : 1
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos: 0
Ipv4pbr : 0
FTOS#
test cam-usage
Verify that enough CAM space is available for the IPv6 ACLs you have created.
S4820T
Syntax
test cam-usage service-policy input input policy name linecard
{number | all}
Parameters
policy-map name Enter the name of the policy-map to verify. Maximum is 32 characters.
number Enter all to get information for all the linecards/stack-units or enter
the linecard/ stack-unit number to get information for a specific card.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced.
Usage
Information
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when verifying QoS
optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a
single (or the first of several) interfaces. It is most useful when a policy is applied across
multiple interfaces; it can reduce the impact to CAM usage across subsequent interfaces.
The following describes the test cam-usage command shown in the following example.
Term
Explanation
Linecard Lists the line card or linecards that are checked. Entering all
shows the status for linecards in the chassis.
390