Reference Guide

dcb-policy output stack-unit stack-ports all
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
S4820T
Syntax
dcb-policy output stack-unit {all | stack-unit-id} stack-ports
all dcb-output-policy-name
To remove all DCB output policies applied to the stacked ports, use the no dcb-policy
output stack-unit all command.
To remove only the DCB output policies applied to the specified switch, use the no dcb-
policy output stack-unit command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-output-
policyname
Enter the policy name for the DCB output policy.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The dcb-policy output stack-unit all command overwrites any previous dcb-
policy output stack-unit stack-unit-id configurations. Similarly, a dcb-
policy output stack-unit stack-unit-id
command overwrites any previous
dcb-policy output stack-unit all configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a switch stack
or an individual stacked switch. You can apply different DCB output policies to different stack
units.
Related
Commands
dcb-policy input stack-unit stack-ports all — applies the specified DCB input policy.
description
Enter a text description of the DCB policy (PFC input or ETS output).
S4820T
Syntax
description text
To remove the text description, use the no description command.
417