Reference Guide

• priority-list — configures the 802.1p priorities.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and
bandwidth allocation.
S4820T
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
Enter the port-type slot and port ETS information.
{summary | detail} Enter the keyword summary for a summary list of results or enter the
keyword
detail for a full list of results.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Down status messages added.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To clear ETS TLV counters, use the clear ets counters interface port-type
slot/port
command.
The following describes the show interface summary command shown in the following
example.
Field Description
Interface Interface type with stack-unit and port number.
Max Supported TC
Group
Maximum number of priority groups supported.
Number of Traffic
Classes
Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off. When on, the scheduling and bandwidth
allocation configured in an ETS output policy or received in a DCBX
TLV from a peer can take effect on an interface.
Admin Parameters ETS configuration on local port, including priority groups, assigned
dot1p priorities, and bandwidth allocation.
Remote Parameters ETS configuration on remote peer port, including admin mode
(enabled if a valid TLV was received or disabled), priority groups,
424