Reference Guide

-m HMAC
algorithm
Enter one of the following HMAC algorithms to use. (For v2 clients
only.):
Without the FIPS mode enabled:
• hmac-sha1: Force ssh to use the hmac-sha1 HMAC
algorithm.
• hmac-shal-96: Force ssh to use the hmac-sha1–96 HMAC
algorithm.
• hmac-md5: Force ssh to use the hmac-md5 HMAC
algorithm.
• hmac-md5–96: Force ssh to use the hmac-md5–96 HMAC
algorithm.
With the FIPS mode enabled:
• hmac-sha1: Force ssh to use the hmac-sha1 HMAC
algorithm.
• hmac-sha1–96: Force ssh to use the hmac-sha1–96 HMAC
algorithm.
-p port-number (OPTIONAL) Enter the keyword —p then the port number.
The range is 1 to 65536
The default is 22
-v {1|2} (OPTIONAL) Enter the keyword —v then the SSH version 1 or 2.
The default: The version from the protocol negotiation.
NOTE: If the FIPS mode is enabled, this option does not display in
the output.
Defaults As indicated above.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1(0.0) Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Related
Commands
ip ssh server Configure an SSH server.
show ip ssh
client-pub-keys
Display the client-public keys.
Usage
Information
FTOS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing.
Inbound SSH supports accessing the system through the management interface as well as
through a physical Layer 3 interface.
490