Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T
51525354555657585960
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip
access-list standard or ip access-list extended command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip access-list standard or ip access-list extended command. Include a name for the
ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to Intermediate
System to Intermediate System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER ISIS mode.
2. Enter the command address-family ipv6 unicast. The prompt changes to include (conf-router_isis-
af_ipv6).
LLDP Mode
To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, refer to Link Layer
Discovery Protocol (LLDP).
To enter LLDP mode:
1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface,
verify that you are logged in to INTERFACE mode.
2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-
interface
-lldp).
LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT
INTERFACE mode. For more information, refer to Enabling LLDP on Management Ports.
To enter LLDP MANAGEMENT INTERFACE mode:
1. Verify that you are logged in to LLDP mode.
2. Enter the management-interface command. The prompt changes to include (conf-lldp-mgmtIf).
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the line command. Include the keywords console or vty and their line number available on the switch.
The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
51