Reference Guide

• Port Channel interface: enter the keyword port-
channel then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the
keyword TenGigabitEthernet then the slot/port
information
• 40-Gigabit Ethernet interface: enter the
keyword fortyGigE then the slot/port information
secondary
interface
Enter the keyword secondary to configure the secondary interface
then one of the following interfaces and slot/port information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel
then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the
keyword
TenGigabitEthernet then the slot/port
information
• 40-Gigabit Ethernet interface: enter the
keyword fortyGigE then the slot/port information
control-vlan vlan-
id
Enter the keyword control-vlan then the VLAN ID. The range is
from 1 to 4094.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
Usage
Information
This command causes the Ring Manager to take ownership of the two ports after IFM validates
the configuration. Ownership is relinquished for a port only when the interface does not play a
part in any control VLAN, that is, the interface does not belong to any ring.
Related
Commands
show frrp — displays the Resilient Ring Protocol configuration information.
511