Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
S4820T
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced
Usage
Information
This command places you into the resilient ring protocol. After executing this command, the
command line prompt changes to conf-frrp.
513