Reference Guide

show frrp
Display the resilient ring protocol configuration.
S4820T
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized
version of the Ring configuration.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
Usage
Information
Executing this command without the optional ring-id command clears the statistics
counters on all the available rings. FTOS requires a command line confirmation before the
command executes. This command clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Usage
Information
Executing this command without the optional ring-id command clears the statistics
counters on all the available rings. FTOS requires a command line confirmation before the
command is executed. This command clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Example
(Summary)
FTOS#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
FTOS#
514