Reference Guide

debug gvrp
Enable debugging on GVRP.
S4820T
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config Enter the keyword config to enable debugging on the GVRP
configuration.
event Enter the keyword event to enable debugging on the JOIN/LEAVE
events.
pdu Enter the keyword pdu then one of the following Interface keywords
and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Disabled.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
519