Reference Guide

disable
Globally disable GVRP.
S4820T
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
S4820T
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all}
command.
Parameters
join Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds to
configure the leave time. The range is from 100 to 2147483647
milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
520