Reference Guide

redundancy auto-failover-limit
Specify an auto-failover limit for RPMs. When a non-recoverable fatal error is detected, an automatic RPM failover
occurs. This command does not affect user-initiated (manual) failovers.
S4820T
Syntax
redundancy auto-failover-limit [count number [period minutes] |
period minutes]]
To disable the auto-failover limit control, use the no redundancy auto-failover-
limit command.
Parameters
count number Enter the number of times the RPMs can automatically failover within
the period defined in the period parameter. The range is from 2 to 10.
The default is 3.
period minutes Enter a duration in which to allow a number of automatic failovers
(limited to the number defined in the count parameter). The range is
from 5 to 9000 minutes. The default is 60 minutes.
Default
• Count: 3
• Period: 60 minutes
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series
Usage
Information
If you disable auto failover, enter the redundancy auto-failover-limit (without any
parameters) to set auto failover to the default parameters (Count 3, Period 60 minutes). To view
the redundancy status, use the show redundancy command.
When you change one or both of the optional parameters, FTOS checks that the interval
between auto failovers is more than five (5) minutes. If the interval is less, FTOS returns a
configuration error message.
531