Reference Guide

Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the
Management port, use the
ip address command.
If your system has two RPMs installed, use the show redundancy command to display
which RPM is the Primary RPM.
Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Related
Commands
management route — configures a static route that points to the Management interface or a
forwarding router.
duplex (Management) — clears the forwarding information base (FIB) entries on a specified
line card.
speed (Management interface) — clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
S4820T
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
576