Reference Guide

Example (Single
Range)
This example shows the macro named test that was defined earlier.
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
FTOS
Related
Commands
interface range — configures a range of command (bulk configuration).
interface range macro (define) — defines a macro for an interface range (bulk configuration).
interface vlan
Configure a VLAN. You can configure up to 4096 VLANs.
S4820T
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is from 1 to 4096.
of-instance{ of-id } Enter the keyword of-instance then the OpenFlow instance ID to add
the VLAN to the specified OpenFlow instance. The range is from 1 to
8.
NOTE: Associate the OpenFlow instance with the VLAN when the
VLAN is created. An existing VLAN cannot be associated with an
OpenFlow instance.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
For more information about VLANs and the commands to configure them, refer to the Virtual
LAN (VLAN) Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. For more information, refer to the Access Control Lists (ACL)
chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
582