Reference Guide

Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual interface.
show interfaces transceiver — displays the physical status and operational status of an
installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s
serial number.
S4820T
Syntax
show interfaces [gigabitethernet slot/port | tengigabitethernet
slot/port | fortyGigE slot/port] transceiver
Parameters
gigabitethernet For a 10/100/1000 interface, enter the keyword gigabitethernet
then the slot/port information.
tengigabitetherne
t
For a 10G interface, enter the keyword tengigabitethernet
then the slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the slot/
port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Output augmented with diagnostic data for pluggable media.
Version 7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, and
Vendor PN.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 6.5.4.0 Introduced on the E-Series.
Usage
Information
The following describes the show interfaces transceiver command shown in the
following example.
606