Reference Guide

100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its
speed.
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the
Primary or Standby RPM).
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with the speed set
to 10/100.
management route — configures a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Split a single 40G port into 4-10G ports on the S4820T .
S4820T
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
For the S4820T, the range is from 0 to 11.
number Enter the port number of the 40G port to be split. For the S4820T, enter
one of the following port numbers: 48, 52, 56, or 60.
Defaults Disabled.
Command Modes CONFIGURATION
615