Reference Guide

Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP mode to
configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical interfaces on the S-
Series.
S4820T
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number
command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel
then a number. The range is from 1 to 128.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on S4810.
Version 8.3.11.1 Introduced on Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale.
Version 7.6.1.0 Introduced on S-Series.
Version 7.5.1.0 Introduced on C-Series.
624