Reference Guide

Related
Command
group — groups two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel — displays information on configured Port Channel groups.
show config
Display the current configuration of the selected LAG.
S4820T
Syntax
show config
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
S4820T
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-number For a Port Channel interface, enter the keyword port-channel
then a number. For the C-Series and S-Series, the range is from 1 to
128.
brief (OPTIONAL) Enter the keyword brief to display only the port
channel number, the state of the port channel, and the number of
interfaces in the port channel.
627