Reference Guide

Defaults Debug disabled.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Example
FTOS#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 5/0 with IP DA (0xffffffff) will be
sent on Gi 5/1 Gi 5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 7/0 is handed over for DHCP
processing.
Related
Commands
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface.
show ip udp-helper — displays the configured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Configure an IP UDP address for broadcast.
S4820T
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE (config-if)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
635