Reference Guide

crypto ipsec policy
Create a crypto policy used by ipsec.
S4820T
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-num
ipsec-manual command.
Parameters
name Enter the name for the crypto policy set.
seq-num Enter the sequence number assigned to the crypto policy entry.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
This command creates a crypto policy entry and enters the crypto policy configuration mode
for configuring the flow parameters.
Example
FTOS(conf)#crypto ipsec policy West 10 ipsec-manual
FTOS(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
S4820T
Syntax
management crypto-policy name
To remove the management traffic crypto policy, use the no management crypto-
policy
name command.
Parameters
name Enter the name for the crypto policy..
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
641