Reference Guide

Parameters
access-group
name
Enter the keyword access-group then the access list name
(maximum 16 characters) to limit the debug output based on the
defined rules in the ACL.
count value (OPTIONAL) Enter the keyword count then the count value. The
range is from 1 to 65534. The default is
Infinity.
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information. The
slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. For the C-Series and S-Series, the
range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior
limit was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Added the access-group option.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.3.1.0 Added the count option.
Usage
Information
The following describes the debug ip packet command in the following example.
659