Reference Guide

CP DOWNLOAD BOOT invalid invalid

RP1 DOWNLOAD BOOT invalid invalid

RP2 DOWNLOAD BOOT invalid invalid

show bootvar

Display the variable settings for the boot parameters.

S4820T

Syntax

show bootvar

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.4 Output expanded to display current reload mode (normal or

Jumpstart).

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Example

FTOS#show bootvar

PRIMARY IMAGE FILE = ftp://box:password@10.31.1.205//home/

5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin

SECONDARY IMAGE FILE = variable does not exist

DEFAULT IMAGE FILE = flash://FTOS-ED-5.3.1.0.bin

LOCAL CONFIG FILE = variable does not exist

PRIMARY HOST CONFIG FILE = variable does not exist

SECONDARY HOST CONFIG FILE = variable does not exist

PRIMARY NETWORK CONFIG FILE = variable does not exist

SECONDARY NETWORK CONFIG FILE = variable does not exist

CURRENT IMAGE FILE = ftp://box:password@10.31.1.205//home/

5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin

CURRENT CONFIG FILE 1 = flash://startup-config

CURRENT CONFIG FILE 2 = variable does not exist

CONFIG LOAD PREFERENCE = local first

BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist

FTOS#

Commands

boot config — sets the location of configuration files on local devices.

boot host — sets the location of configuration files from the remote host.

boot network — sets the location of configuration files from a remote network.

boot system — sets the location of FTOS image files.