Reference Guide

ip domain-list
Configure names to complete unqualified host names.
S4820T
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
name Enter a domain name to be used to complete unqualified names (that
is, incomplete domain names that cannot be resolved).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
To configure a list of possible domain names, configure the ip domain-list command up
to six times.
If you configure both the ip domain-name and ip domain-list commands, the
software tries to resolve the name using the
ip domain-name command. If the name is not
resolved, the software goes through the list of names configured with the ip domain-list
command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related
Commands
ip domain-name — specifies a DNS server.
663