Reference Guide

ip route
Assign a static route to the switch.
S4820T
Syntax
ip route {destination mask {ip-address | interface [slot/port]
| [tunnel tunnel-id] [distance] | [permanent] | tag tag-value}}
To delete a specific static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination
mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination
device.
mask Enter the mask in the slash prefix format (/x) of the destination IP
address.
ip-address Enter the IP address of the forwarding router in dotted decimal
format.
interface slot/port Enter the keyword interface then the slot/port number.
tunnel tunnel-id Enter the keyword tunnel then the tunnel ID.
distance (OPTIONAL) Enter the value of the distance metric assigned to the
route. The range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route
must not be removed even if the interface assigned to that route goes
down. The route must be currently active to be installed in the routing
table. If you disable the interface, the route is removed from the
routing table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the
route. The range is from 1 to 4294967295.
bfd Enter the keyword bfd to use bidirectional forwarding detection.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2.(0.0) Added support for tunnel interface type.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
672