Reference Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Added support for IPv6.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
management route
Configure a static route that points to the Management interface or a forwarding router.
S4820T
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet}
To remove a static route, use the no management route{{ip-address mask |
{ipv6-address prefix-length}}{forwarding-router-address |
managementethernet}
command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format)
of the destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of
the destination subnet. Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
678