Reference Guide

ecmp-group
{detail | member-
info [detail
[group-index
index-number ]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member
information for the ECMP group.
• Enter the keyword member-info detail to view
detailed ECMP membership and n-hop information.
• Enter the keyword group-index then the index number to
show ECMP membership per group. The range is from 0 to
1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip cam command shown in the following example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for
the default route for non-Jumbo line cards. For Jumbo line cards,
displays 0,1 when ECMP is more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is
forwarded to the CP or RP2, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
688