Reference Guide

Parameters
id Enter the S-Series stack unit ID. The unit ID range is from 0 to 11 for
the S4820T.
ip-address mask (OPTIONAL) Enter the IP address of the network destination to view
only information on that destination. Enter the IP address in dotted
decimal format (A.B.C.D). Enter the mask in slash prefix format (/X).
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
summary (OPTIONAL) Enter the keyword summary to view the total number of
prefixes in the FIB.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip fib stack-unit command shown in the following
example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly
connected route or the remote IP address used to forward the
traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC Displays the number of ECMP paths.
Example
FTOS#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00
692