Reference Guide

Port VId EC
-------------
BLK HOLE 0 0
FTOS>
Related
Commands
clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S4820T
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface
interface
Enter the keyword interface then one of the following interface
keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address in IP
address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination
address in IP address format.
protocol number
[tcp | udp]
Enter the keyword protocol then one of the protocol type
keywords:
tcp, udp, or protocol number The protocol number
range is from 0 to 255. .
src-port number Enter the keywords src-port then the source port number.
destination-port
number
Enter the keywords destination-port then the destination port number.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
693