Reference Guide

• For the Null interface, enter the keyword null then zero (0).
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a stack-unit interface, enter the keyword stack-unit
then the stack unit number. The range is from 0 to 7.
• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical
interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Supported on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following
example.
Lines
Description
TenGigabitEthernet
0/0...
Displays the interface’s type, slot/port, and physical and line protocol
status.
695