Reference Guide

Related
Commands
ip prefix-list — enters CONFIGURATION-IP PREFIX-LIST mode and configures a prefix list.
show ip prefix-list summary — displays a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
S4820T
Syntax
show ip route summary
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip route summary shown in the following example.
Column Heading Description
Route Source Identifies how the route is configured in FTOS.
Active Routes Identifies the best route if a route is learned from two protocol
sources.
Non-active Routes Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes down, the
non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are
advertised, then information on those routes is displayed.
704