Reference Guide

show tcp statistics
View information on TCP traffic through the switch.
S4820T
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
all Enter the keyword all to view all TCP information.
cp Enter the keyword cp to view only TCP information from the Control
Processor.
rp1 Enter the keyword rp1 to view only TCP statistics from Route
Processor 1.
rp2 Enter the keyword rp2 to view only TCP statistics from Route
Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 6.4.1.0 Introduced
Usage
Information
The following describes the show tcp statistics cp command shown in the following
example.
Field Description
Rcvd: Displays the number and types of TCP packets received by the
switch.
• Total = total packets received
• no port = number of packets received with no designated
port
0 checksum error... Displays the number of packets received with the following:
• checksum errors
• bad offset to data
• too short
329 packets... Displays the number of packets and bytes received in sequence.
708