Reference Guide

Parameters
source address Enter the IPv6 address of the network or host from which the packets
were sent in the x:x:x:x::x format then the prefix length in the /x
format. The range is from /0 to /128. The :: notation specifies
successive hexadecimal fields of zero.
mask Enter a network mask in /prefix format (/x).
host ipv6-address Enter the keyword host then the IPv6 address of the host in the
x:x:x:x::x format. The :: notation specifies successive hexadecimal
fields of zero.
destination
address
Enter the IPv6 address of the network or host to which the packets
are sent in the x:x:x:x::x format then the prefix length in the /x format.
The range is from /0 to /128. The :: notation specifies successive
hexadecimal fields of zero.
message-type (OPTIONAL) Enter an ICMP message type, either with the type (and
code, if necessary) numbers or with the name of the message type.
The range is from 0 to 255 for ICMP type and from 0 to 255 for ICMP
code.
count (OPTIONAL) Enter the keyword count to count packets the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
log (OPTIONAL) Enter the keyword log to have the information kept in an
ACL log file.
monitor (OPTIONAL) Enter the keyword monitor to monitor traffic on the
monitoring interface specified in the flow-based monitoring session
along with the filter operation.
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale. Added the monitor option.
714